HYBREX G1E, Installation & Programming Manual

Page: 88 / 219

72
Issue 3.3.2 / April, 2011
Program 05-06-IP : System Timing Parameters – 06
05-06-IP SYS PAR
7 4 0 0 0 3 0 0
IP = 01-08
System Default.
Item
Display Timing
Pointer Data Programming Data Description Table Default
--------- ----------- --------------------------------------------------- ------------ ---------------
01 0-9 TRF Busy Recall Timeout M 7=60 Sec.
02 0-9 TRF Idle Recall Timeout M 4=30 Sec
03 0-1 ISDN Audio 0=a law
04 0-9 Polarity Reversal 0=disable
05 0-1 Operator Code 0=0
06 0-9 Unsupervised Conference And ECF Time Setting 3=3 Min.
07 0-1 Hold Method for SLT 0=Flash
08 0-2 Station Hunting Group Ring Method 0=Common
Description:
01. Transfer Busy Recall Timeout:
This parameter sets the time duration between transferring a call to a busy party and automatic transfer
back to the transferring party when the called party is busy.
02. Transfer idle Recall Timeout:
This parameter sets the time duration between transferring a call to a station and automatic transfer
back to the transferring party when the called party does not answer.
See timing table Grade M for parameters of these 2 features.
03. ISDN Audio
This parameter sets ISDN Audio type. It should never be necessary to change this mode as the software
defaults will be set for each market.
0 = a law 1 = u law
04. Polarity Reversal:
This parameter is to enable the Polarity Reversal detection feature for incoming caller hang up detection
in Australia and some European countries. See Mode 14-01-08 for SMDR setting. Telecom will need to
enable polarity reversal at the exchange. When reversal is enabled the system will hang up the
exchange line when the incoming caller hangs up and the exchange sends a reversal to the system.
0 = Disable
1 = Enable for 1 second delay.
2 = Enable after 2 seconds delay.
2-9 =Delay for 1-8 Seconds and then detect Polarity Reverse Signal