HYBREX G1E, Installation & Programming Manual

Page: 177 / 219

G1E Programming Manual
161
Program 67-gp-IP : Hunt Group Pilot Number
67-gp HUNT NO
- - - 0
GP = 01-10
System default
Item Display
Pointer Data Programming Data Description Default
---------- ---------- ----------------------------------------------------------- -----------
01 00-10 Hunting Group Pilot Number _ _ _
02 0-9 Hunting Group Ring Method 0 = Common
General:
This program sets Pilot Numbers for Hunting Groups 1 to 10 and their ringing method.
Description:
01. Hunting Group Pilot Number:
There are 10 Hunt Groups available in the G1E. Each Hunt Group is assigned a Pilot Number in this Mode. The
pilot number can be any valid unused number and will have the same number of digits as the station-numbering
scheme used in the system (2, 3 or 4).
On the G1E+ Hunt group pilots can be assigned to be rung from Single Digit DISA.
02. Hunting Group Ringing Method:
Assign one of 3 ringing methods for each hunting group.
0 = Common
1 = Linear 2 = Circular
4 = Common enable CFW 5 Linear ring enable CFW 6 = Circular ring enable CFW
Once Hunting Ring Type is set here or in Mode 05-06-08 then ringing this pilot number will access the stations in
the group according to the ringing method selected and the order in which they are programmed in Mode 68
(Day) and Mode 69 (Night). Each Hunt Group can be from 1 to 16 stations.
There are 3 types of Ring available, Common, Linear and Circular.
If
Common Ring is enabled then calling the pilot number will always ring all available stations in which they are
programmed in Mode 68 or 69.
If
Linear Ring is enabled then calling the pilot number will always call the first available station in the order in
which they are programmed in Mode 68 or 69.
If
Circular Ring is enabled then the stations will be called one after the other for each succeeding call until all
have taken a call and then the Ring will revert to the beginning of the Ring assignment and then repeat the
process.
Rules for Call Forward of calls to Hunt group
Intercom calls to the Hunt group will call forward to an extension, but not to a SPD Dial.
DISA call Hunt group only the first extension in Hunt group can make all call forward to SPD dial .
Stations can remove themselves from receiving Hunt calls by using the DND key but this will also prevent them
from receiving direct calls.
It is still possible to call each station in the Hunting group directly by dialling it's own individual station number.
If a station in a Hunt Group has set call forward to a station or another Hunt Group (for instance Voice Mail
Group) then only direct calls to the station will be forwarded. If Hunt calls come to the station and it is call
forwarded it will still ring for the call for settings 0,1,2 but will follow CFW setting of first station if set to 4,5,6
Related System Programming Modes: 05-06-08, 67, 68, 69