Huvema HU 300 HAC-4 Topline, Instruction Manual

Page: 45 / 86

44
45 ° is necessary to prevent a strike of the saw frame on the control
panel
15 Setting For sawing machine
15.1 vise - play adjustment on the guide rails
The selector switch to open.
Open the chuck completely, loosen all screws and nuts.
Then screw the first two screws, and then again a ¼ Solve rotation to adjust
the guide.
Then the vice with the hand wheel close to the next screw on the vice are
lower part.
Aligned in the same way to all, with the fixed part of the vise
Screws proceed and then block with the lock nuts. The Close vise and set the
remaining screws.
Again to open and close the vise check the setting; when necessary, repeat
the adjustment.
It is important to ensure that only the screws are tightened on to the vise base
are, otherwise the guide bar is bent.
15.2 Band saw - Setting the saw band shoes when changing the tape