Huvema HU 300 HAC-4 Topline, Instruction Manual

Page: 42 / 86

41
* Load the work piece in the vise and hand with the hand wheel
Clamp, now the vise to open about a half turn back
the selector switch to position "closed chuck" position.
*provide the feed regulator to zero
*Select speed of the saw blade.
* Semi-automatic cycle start with the start button.
*If the average initial probe has touched the work piece surface, the Set lowering the feed
regulator.
The saw frame always goes in the "Rapid traverse" down until the cutting start
button triggers.
Then the downward movement over the value set on the feed regulator is
determined.
After triggering the cut end switch of the saw arm moves in the "Rapid traverse"
after up and stops about 1cm above the material and the vise can be opened will
The work piece support in an appropriate way so that it does not fall.
If very short work pieces to be cut, it must be ensured,
That they are not dragged along the cut end and / or with the hook bandsaw blade
14.5 ESC Electronic Speed Control