Huvema HU 300 HAC-4 Topline, Instruction Manual

Page: 8 / 86

7
2.Noise of Machine
Measurements at different times performed about to draw the various
operating conditions into consideration, the workpiece is hits -only during
cutting by workflow along with the tool when it
Is arised on by the simultaneous operation of more moving elements - each
workplace under noise 2 the conditions indicated below generated NOISE
MACHINE
The operating conditions are with all machines as follows: average of 3
measurements: left side / front / right side.This result of each
measurement is expressed in dBA and meets to be setted up .the device is
within 1 m and about 1.60 m on the bottom of solid steel (St12 = ~ C20 80
mm diam.): dBA 75during the cut at a suitable rotation speed idle (at
maximum engine speed with built-in blade: 63 dBA of the workplace to be
considered while assessing the other powered machines and the properties
protective equipment (ear muffs, ear plugs) is recommended .
The operator predict prolonged exposure to higher levels of use through is
that these values are exceeded, the proportions and noise the clamping
system ab. the generated depends largely on the
material of the material to be cut, its harm the health of workers
and the good success of the work .wrong tools caused a significant change