Huvema HU 300 HAC-4 Topline, Instruction Manual

Page: 44 / 86

43
1 clamping screw for adjustment of the attacks
2. Stop for miter 45 ° right
3. Stop 90 °
4.Miter clamp lever
1 stop for miter 45 ° and 60 °
For cuts 45 ° left to stop (1) Around.
14.8 Overload protection
The motor is protected from overheating by a thermal protection device
This is used directly in the coil of the motor, and interrupts the control circuit.
The resumption of the operation is only possible after the temperature
The set trip level has dropped.
In the meantime, the root causes for hot running, for example, in the work piece
retarded band saw blade stuck to high cutting speed, lack of oil in the
Transmission, are short circuit in motor etc. wanted and corrected.
14.9 Position of the operating unit
Loosen the control unit located under the clamping lever, so that the
Control unit can be rotated. This is particularly miter cuts on