Huvema HU 300 HAC-4 Topline, Instruction Manual

Page: 35 / 86

34
up / take down.
When no hydraulic pressure is built up within the first 5-10 seconds
the machine with the main power switch off, unplug the power cord,
the connection of two phases in the plug swap, but not the green / yellow ground
wire, and start at point a) once more.
12.3 Compressed air connection (if necessary for minimal lubrication)
The machine should be connected to a system that at least
Water separator, filter and pressure regulator has to control the pressure to
stabilize.
13 Blade tension
The machine is supplied with a tensioned belt (the engine start is only possible if
the belt is properly tensioned.) If this is not the case, it should be checked off
machine that the band did not slip out of the guide.
This opening the guard, and checks that the strip is seated on the wheels and is
properly inserted in the guide shoes if necessary, of the belt-tension to loosen
a few turns, Insert the tape again and close the hood again, making sure that the
machine at the main switch, wait a few seconds until the Controller is powered
up.
Then the white light should be lit. The saw blade easily Pretension and close the