Huvema HU 300 HAC-4 Topline, Instruction Manual

Page: 41 / 86

40
Check that the work piece is actually clamped between the jaws
and the closing force is sufficient, but no deformation of the Caused material.
Bring the front saw belt into position so that if Down stroke does not bump against
the work piece or the jaw, to the
Clamping (1), loosen and slide the guide
Always find the clamp (1) before other switches are operated.
1. Clamping screw for front
saw band
* set the cut end switch (2) so that the work piece also is actually cut.
1 Average start switch
2. Cut end switch
14.3 Operation (Semi-automatic cycle)
After turning on the main switch, the indicator lights must be on,
then the hydraulic button must be pressed to the hydraulic unit to
start (when the machine is not used 10 minutes, turns the Hydraulic automatically).