Huber MPC TC 100, Operation Manual

Page: 35 / 48

Normal operation
Chapter 5 OPERATION MANUAL
V2.3.0en/03.08.21//1.30
Immersion Cooler
35
5 Normal operation
5.1 Automatic operation
Extremely hot / cold surfaces, connections and thermal fluids
BURNS/FREEZING OF LIMBS

Surfaces, connections and tempered thermal fluids can be extremely hot or cold depending on
the operating mode.

Avoid direct contact with surfaces, connections and thermal fluids!

Wear your personnel protective equipment (e.g. temperature-resistant safety gloves, safety
goggles).
The cooling coil is moved / bent when cold.
MATERIAL DAMAGE CAUSED BY INTERNAL FRACTURE

The cooling coil may only be moved / bent when the cooling coil temperature is at room tem-
perature.
5.1.1 Temperature control
5.1.1.1 Starting the temperature control process - without controller
The temperature control process can be started after the probe has been placed in the thermal
fluid. → Page 34, section »Turning on the temperature control unit - without controller« .
5.1.1.2 Ending the temperature control process - without controller
To stop the temperature control process, proceed as described. → Page 34, section »Turn tempera-
ture control unit off - without controller« .
5.1.1.3 Starting the temperature control process - with controller
The temperature control process can be started after the probe has been placed in the thermofluid.
PROCEDURE

Switch on the temperature control unit. → Page 34, section »Turning off the temperature con-
trol unit / with controller« .

Set the desired setpoint. → Page 32, section »Set/change setpoint« . The setpoint can not be
changed while a temperature control process is running.

With the temperature control unit switched on and the temperature control process/circulation
stopped, press the >Start/Stop button< [E].
The temperature control process starts.
5.1.1.4 Ending the temperature control process - with controller
Thermoregulation can be terminated at any time.
PROCEDURE

With the temperature control unit switched on and the temperature control process/circulation
running, press the
>Start/Stop button<
[E].
Temperature control stops. The temperature control unit is in standby mode.

Switch off the temperature control unit. → Page 34, section
»Turning off the temperature con-
trol unit - with controller«
.