Huber MPC TC 100, Operation Manual

Page: 42 / 48

Shutting down
OPERATION MANUAL Chapter 8
Immersion Cooler
V2.3.0en/03.08.21//1.30
42
8 Shutting down
8.1 Safety instructions and basic principles
Connection/adjustment to the power supply not carried out by an electrician and/or connection
to a power socket without protective earth (PE)
MORTAL DANGER FROM ELECTRIC SHOCK

Have the connection/adjustment to the power supply carried out by an electrician.

Always connect the temperature control unit to safety sockets (PE).
Damaged power cable/power cable connection
MORTAL DANGER FROM ELECTRIC SHOCK

Do not start up the temperature control unit.

Isolate the temperature control unit from the power supply.

Have the power supply cable/power supply connection replaced and inspected by an electrician.

Do not use a power cable that is longer than 3 m .
Risk of tipping due to unstable temperature control unit
SERIOUS INJURY AND PROPERTY DAMAGE

Avoid risk of tipping due to unstable temperature control unit.
All safety instructions are important and must be followed accordingly during working operations!
8.2 Switch-off
PROCEDURE

Turn off the temperature control unit.

Disconnect the temperature control unit from the power supply connection.
8.3 Remove probe [67] from thermal fluid
The >Probe< [67] is touched in icy condition
SEVERE FROSTBITES CAUSED BY HOUSING PARTS

The
>Probe<
[67]
must not
be touched in icy condition.

Wear your personnel protective equipment (e.g. temperature-resistant safety gloves, safety
goggles, safety footwear).
The protective and insulating hose is twisted or bent
DAMAGE TO THE TEMPERATURE CONTROL UNIT

Ensure the protective and insulating hose is never bent or twisted.
The protective and insulating hose is immersed into the thermofluid
DAMAGE TO THE TEMPERATURE CONTROL UNIT

Ensure the protective and insulating hose is not immersed into and does not come into contact
with the thermofluid.
The cooling coil is moved / bent when cold.
MATERIAL DAMAGE CAUSED BY INTERNAL FRACTURE

The cooling coil may only be moved / bent when the cooling coil temperature is at room tem-
perature.