Huber MPC TC 100, Operation Manual

Page: 14 / 48

Introduction
OPERATION MANUAL Chapter 1
Immersion Cooler
V2.3.0en/03.08.21//1.30
14
Improper use
SERIOUS INJURY AND PROPERTY DAMAGE

Store the operation manual where it is easy to access in close proximity to the temperature
control unit.

Only adequately qualified operators may work with the temperature control unit.

Operators must be trained before handling the temperature control unit.

Check that the operators have read and understood the operation manual.

Define precise responsibilities of the operators.

Personal protective equipment must be provided to the operators.

Be sure to follow the responsible body’s safety rules to protect life and limb and to limit dam-
ages!
Modifications to the temperature control unit by third-parties
DAMAGE TO THE TEMPERATURE CONTROL UNIT

Do not allow third parties to make technical modifications to the temperature control unit.

The EU declaration of conformity becomes invalid if any modifications are made to the tem-
perature control unit without the approval of Huber.

Only specialists trained by Huber may carry out modifications, repairs or maintenance work.

The following must be observed without fail:

Only use the temperature control unit in a fault-free condition!

Have the start-up and repairs carried out by specialists only!

Do not ignore, bypass, dismantle or disconnect any safety devices!
The temperature control unit must not be used for any purposes other than temperature control in
accordance with the operation manual.
The temperature control unit is made for industrial use. The temperature control unit is solely intended as
a cooling device for cooling liquids in containers. The containers used must be resistant to temperature
and thermal fluids. The temperature control unit does not have an overtemperature protection and must
be additionally protected when used with heating elements. Note the temperature control unit’s maxi-
mum operating temperature. The installation in public buildings is prohibited. Only use thermal fluids
suitable for the overall system. The cooling capacity is provided at the >Probe< [67]. For the technical
specification, refer to the datasheet. → From page 46, section »Annex« . Install, set up and operate the
temperature control unit according to the instructions in this operation manual. Any failure to comply
with the operation manual is considered as improper operation. The temperature control unit was manu-
factured according to the state of the art and the recognized safety rules and regulations. Safety devices
are installed in your temperature control unit.
1.3.4 Reasonably foreseeable misuse
Use with medical devices (e.g. in Vitro diagnostic procedure) or for direct foodstuff temperature
control is NOT permissible.
The temperature control unit must NOT be used for any purposes other than temperature control in
accordance with the operation manual.
The manufacturer accepts NO liability for damage caused by technical modifications to the temper-
ature control unit, improper handling or use of the temperature control unit if the operation manu-
al is not observed .
1.4 Responsible bodies and operators – Obligations and requirements
1.4.1 Obligations of the responsible body
The operation manual is to be stored where it is easy to access in close proximity to the temperature
control unit. Only adequately qualified operators (e.g. chemists, CTA, physicists etc.) are permitted
to work with the temperature control unit. Operators must be trained before handling the tempera-
ture control unit. Check that the operators have read and understood the operation manual. Define
precise responsibilities of the operators. Personal protective equipment must be provided to the
operators.