HT FULLTEST3, User Manual, Page: 67 / 100

FULLTEST3
EN - 65
Item Description
5
CON (connection) touch-screen key to select measurement
connection (INT or PLUG). Currently selected connection is
displayed on the bottom of the key
6
LIMIT t touch-screen key to select limit time (1 s or 5 s), valid for
internal measurement only. Currently selected limit value is displayed
on the bottom of the key
7
Measurement result (in green colour - result OK, in red colour - result
not OK)
8 Real time clock (hh.mm.ss).
9
Unit of the test result. As measured U
RES
voltage may be alternating
or direct there is an appropriate information AC or DC added to the
unit
10
Measurement result status (symbol in green colour - result OK,
symbol in red colour - result not OK)
9. Save the test result by pressing the
SAVE key (see § 7.1)
CAUTION
Do not use the START/STOP button in this function, it has no
function
6.8.4. Anomalous situations
The following specific information can be shown on the display during measurement
Information displayed Description
Mains voltage was disconnected at too low
momentary voltage (< 20% of peak value).
The message may appear in LINEAR mode
only.
Repeat the measurement (connect and
disconnect the UUT again)!
Mains voltage was not disconnected close
enough to peak value (Up ± 5%) so the
result would be not relevant anyway. The
message may appear in NONLINEAR mode
only.
Repeat the measurement (connect and
disconnect the UUT again)!
LOW TRIGGER VOLTAGE
REPEAT
LOW SWITCH-OFF VOLTAGE
REPEAT