To replace the component, reverse the removal procedure.
Removing and replacing a rear serial port interface (tertiary
riser)
Procedure
1.
Power down the server (
on page 41).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
• Extend the server from the rack (
Extend the server from the rack
on page 42).
• Remove the server from the rack (
Remove the server from the rack
on page 42).
4.
on page 44).
5.
Disconnect the cable.
6.
Remove the tertiary riser cage.
7.
Using a T-10 Torx screwdriver, remove the serial port interface.
80
Removal and replacement procedures
Summary of Contents for ProLiant DL388 Gen10
