Procedure
1.
Back up all server data on the drive.
2.
Determine the status of the drive from the drive LED definitions (
SAS/SATA drive components and LEDs
on page 125).
3.
Remove the drive.
To replace the component, reverse the removal procedure.
Removing and replacing an NVMe drive
An NVMe SSD is a PCIe BUS device. Devices attached to a PCIe bus cannot be removed without allowing
the device and the bus to complete and cease signal/traffic flow.
Procedure
1.
Before removing the NVMe drive, back up all data on all logical NVDIMMs to alternative storage.
CAUTION:
Before removing and replacing the NVMe SSDs, always back up the data on the logical
NVDIMMs. Failure to back up the data will result in data loss.
2.
Observe the NVMe SSD LED status and determine if the server can be powered down.
3.
Power down the server (
on page 41).
4.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
5.
Remove the drive:
a.
Push the Power button.
The Do Not Remove button illuminates and flashes.
b.
Wait until the flashing stops and the Do Not Remove button is no longer illuminated.
c.
Push the Do Not Remove button and then remove the drive.
Removal and replacement procedures
47
Summary of Contents for ProLiant DL388 Gen10
