Removing a DIMM
To remove a DIMM:
1.
Power down the workstation (see
Predisassembly procedures on page 75
).
2.
Disconnect power from the workstation (see
Predisassembly procedures on page 75
).
CAUTION:
To prevent electrical damage to the DIMMs during removal or installation, power off
the workstation and unplug the power cord from the AC power outlet. Otherwise, the workstation
may not recognize the memory changes.
3.
Remove the side access panel (see
Removing the side access panel on page 78
).
4.
If your system has an airflow guide, remove it (see
Removing the airflow guide on page 110
).
5.
Push gently outward on the DIMM socket levers (1) as shown in the following figure.
Figure 5-45
Removing a DIMM
6.
Lift the DIMM straight up (2) and out of the socket, then store the DIMM in an antistatic bag.
118
Chapter 5 Replacing components
ENWW
