Completing the Appliance Setup
45
Continuous Access Storage Appliance Installation and Maintenance Guide
Running the CASA setup utility
To run the CASA setup utility:
1. Set the console display to node 0.
The hp OV CASA Console window opens.
2. Ensure that the hp OV CASA Console window is open in administrative mode.
3. Click setup.
The CASA setup utility window opens (
).
4. Do either of the following:
■
If the Peer Node Settings - General box is populated with values, do not change the
IP address in the Peer IP Address box. This IP address corresponds to the network
information in the InterLink (Bottom Port) box.
■
If the Peer Node Settings - General box is not populated with values, do not specify
the customer’s LAN in the Peer IP Address box. Use the Peer IP address specified in
on page 42, which corresponds to the InterLink connection between the nodes.
InterLink traffic should not be directed over the customer’s LAN.
5. Enter the customer’s public network information in the
LAN Interface - Onboard NIC # 1 box.
6. If the customer uses IP mirroring, enter the MirrorLink network information in the
MirrorLink (Top Port) box.
If the customer is not using IP mirroring, you can accept the default values or set the IP
address to
0.0.0.0
.
7. Click OK.
8. Reboot node 0.
9. Set the console display to node 1 and repeat steps 2 through 7 on node 1.
