Replicating the setup
This section provides information about replicating the workstation setup.
Copying a setup configuration to a single workstation
CAUTION:
A setup configuration is model-specific. File system corruption can result if source and
target workstations are not the same model.
To copy a setup configuration:
1.
Select a setup configuration to copy, and then restart the workstation.
2.
As soon as the workstation powers on, press and hold
F10
until you enter the Computer Setup
(F10) Utility. If necessary, press
Enter
to bypass the title screen.
NOTE:
If you do not press
F10
at the appropriate time, you must restart the workstation, and then
press and hold
F10
again to access the utility.
If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.
3.
Select
File>Replicated Setup>Save to Removable Media
. Follow the instructions on the screen
to create the configuration diskette or USB media device.
4.
Power off the workstation you are configuring and insert the configuration diskette into the diskette
drive or USB media device.
5.
Power on the workstation you are configuring.
6.
Press and hold the
F10
key until you enter the Computer Setup (F10) Utility. If necessary, press
Enter
to bypass the title screen.
7.
Select
File>Replicated Setup>Restore from Removable Media
, and then follow the instructions
on the screen.
8.
Restart the workstation when the configuration is complete.
42
Chapter 4 System management
ENWW
