Installing the airflow guide
1.
Power down the workstation (see
Predisassembly procedures on page 69
).
2.
Disconnect power from the workstation (see
Predisassembly procedures on page 69
).
3.
Remove the side access panel (see
Removing the side access panel on page 72
).
4.
Press the power cables, including P1, down toward the system board between the DIMM slots and
the internal bay, as shown in the following figure.
Figure 5-27
Positioning the chassis cables
5.
Set the airflow guide into the chassis.
a.
Place the edge of the airflow guide between DIMM socket #6 and the CPU heatsink.
Figure 5-28
Installing the airflow guide
b.
Route the power and data cables through the opening next to the internal bay
2
.
ENWW
Removing and installing components
93
