HP Designjet 330, User Manual

Page: 110 / 184

6–8
Company confidential. Pelican User’s Guide, Ed 1, Final. Freeze Status: frozen
This is the cyan on page 6–8 (seq: 110)
This is the black on page 6–8 (seq: 110)
4 Temporarily place the module on a conductive pad, for example the one containing
the new SIMM.
5 Take the new SIMM out of its bag, holding it only by the edges.
6
With the SIMM’s small notch on the left and the metallic edge away from
you, load the SIMM into the slot furthest from you. To do this, first hold
the module at an angle, place the bottom edge in the slot and then push the
top away from you until the module clicks into place.
Slot furthest from you
1910
2
1
7 If you removed a memory module from the slot nearest to you, re-install it in the
same way.
8 Replace the cover plate and screws.
In steps 9, 10 and 11, pay special attention to this warning. Don’t touch the
stainless steel strip that runs the length of the plotter behind the cartridge
carriage; its edge is very sharp. Keep hair, jewelry, clothing, and foreign
objects away from the plotter mechanisms.
Reconfiguring the plotter
To upgrade the HP DesignJet 330 plotter with color
Localization Note. .Treat as new.
W A R N I N G