HP auroraTempo, User Manual

Page: 76 / 300

aurora Tempo - User Guide
4-28 423972
Verifying the Loop
You can set up aurora Tempo to automatically verify that a
loop has been established. It does this by sending out and
receiving back a BER Test pattern.
To do this :
• Press MENU when the
Remote Loop Test
window is
displayed. The
Remote Loop Menu
is displayed.
• Highlight
Loop Verify
and press ENTER or the
RIGHT arrow key to toggle between a tick (
✔
) and
a cross (
✘
). When a tick is displayed aurora
Tempo
verifies that the loop is established.
The
Remote Loop Test
window displays
Loop Verification: Disabled
when the verify feature is
switched off and
Loop Verification: Enabled
when
switched on.
To do this :
2
Note
You can only verify a loop using the
Start Loop Verify
hot
key, if a DSU loopback has been applied. If you have applied
a CSU loopback you can run a BERT to verify the loop.
• Press F3
Start Loop Verify
.
The
Loop Verified
or
Loop Down
is displayed on the
Remote Loop Test
window is displayed.
To stop the loop verification:
• Press F3
Stop Loop Verify
.