Preface-3
Safety and Regulatory Information
For your protection, this product has been tested to various national and international
regulations and standards. The scope of this regulatory testing includes
electrical/mechanical safety, radio frequency interference, ergonomic, acoustic, and
hazardous materials. Where required, approvals obtained from third-party test agencies
are shown on the product label. In addition, various regulatory bodies require some of the
information under the following headings.
USA Radio Frequency Interference
The United States Federal Communications Commission (in 47 CFR Subpart B, of Part 15)
has specified that the following notice be brought to the attention of the users of this
product:
WARNING
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
Summary of Contents for 3000 99x Family
