horsch Titan 34 UW, Operating Instructions Manual

Page: 65 / 71

Gearbox oil change
1
2
Main gearbox
1. Drain plug
2. Filler and level inspection plug
Oil level inspection:
To check the oil level loosen plug (2), the oil
level must reach the bore.
Oil change:
¾
Run the gearbox for a short while, so that the
oil warms up and becomes thinner.
¾
Switch off PTO-shaft and tractor.
¾
Place the old oil collecting basin under the
plug (1) and unscrew both plugs (1 and 2).
¾
Let all oil drain out and then turn the plug (1)
in again.
¾
Fill in new gear oil 80W-90 approx. 5.5 l
through the filler opening (2), until it reaches
the bottom edge.
¾
Turn the filler and oil level inspection plug
back in.
Worm gear
Oil change:
Remove the gearbox to change the oil.
¾
Fix the worms in position with wooden
wedges.
¾
Loosen the three screws for the bracket on
the worm tube.
¾
Pull out the gearbox.
¾
Pull the drive shaft carefully out and lwt the
old oil run into a suitable container.
¾
Fill in approx. 1.5 l of gear oil 80W-90.
¾
Push the drive shaft carefully back in.
¾
Slide the gearbox over the worm and fasten it
with the three screws.
¾
Remove the wooden wedges.
61