horsch Titan 34 UW, Operating Instructions Manual

Page: 62 / 71

Maintenance overview Titan 34 UW
Maintenance location Work instructions Interval
After 10 operating hours
Retighten all screw and plug-in
connections as well as the hydraulic
connections.
Even correctly tightened screw connections can come loose
(e.g. because of material settlements or paint residues
between the screw elements). This can lead to loose screw
connections and leaking hydraulic connections.
Once
Retighten the wheels - all
M18 x 1.5 - 300 Nm
M22 x 1.5 - 510 Nm
¾
initially after 10 hours or 50 km
¾
then after 10 hours or 50 km
¾
then retighten every day, until the screws have settled
and further tightening is no longer possible
¾
then always before the start of the season and every
50 operating hours.
Prior to use
Frame and frame connecting parts Check for condition, tight fit and wear. prior to use
grease Check the oil level prior to use
Oil change - approx. 5.5 l (80W-90) 2 years
Gearbox (without feed pipe) Oil change - approx. 1.5 l (80W-90) 2 years
Wheels, wheel nuts and air pressure Check condition and tight fit. Air pressure up to 3.8 bar prior to use
Caterpillar undercarriages Check alignment and wear prior to use
sliding axle grease 50 h
Discharge gate grease as required
In use
Hydraulic system
Hydraulic system and components Check all hydraulic components and hoses for function,
leak tightness, fastening and chafing
daily
Wheels / brakes
Undercarriage Check state and fastening
Re-tighten the wheel nuts - see above
Check air pressure
Load bearing capacity of tyres in dependence on the air
pressure, see “Technical data”.
daily
Brake lines and hoses Check for damage, squashing and kinks daily
Air reservoir drain daily
Pipe filter Clean daily
Brake Setting, function daily
Safety installations
Road lighting equipment and warning
plates
Check condition and function prior to use
Warning and safety labels Check that they are in place and legible prior to use
58