A-55
The Pitch Curve is used to control variable pitch propellers.
The Pitch function works nearly identically to a programmable
curve mix, allowing up to 8 points to be stored and adjusted
throughout the curve. Two curves are available (Pos0 and Pos1)
and are selectable with various switches, flight modes, throttle
position or Stick positions (SPS). An Exponential function is
available that smooths the pitch curve. Pitch must be assigned
to Gear, Aux2 or Aux 3 channels in device select to be able to
access the Pitch function. The Pitch curve mixes the throttle
channel to the channel that is selected as PIT in the device
select mode.
Note
: PIT (Pitch) must be selected in Device select for the
GEAR, AUX2 or the AUX 3 channel to allow access to the
Pitch Curve Function.
The points that can be adjusted are listed vertically by name
(Point-L, 1, 2, H, etc.) and are also displayed by number on the
graph.
Change the value of a point by highlighting and selecting the
point name and adjusting the desired percentage.
68: Pitch Curve
Point Names/Numbers
Current Point Setting
This list shows the setting for each of the 8 adjustable points
(Point-L, 1, 2, 3, 4, 5, 6, H). The value of each point determines
where the point is positioned vertically on the graph, which
dictates the Pitch servo position relative to the throttle. The
point values can be set from 0 to +100.
The value for a point can be changed by highlighting and
selecting the Point Name to the left of the point value and then
adjusting the desired value.
Pressing the CLR button when a point value is highlighted
resets the point to original settings.
Summary of Contents for JR DSM 12X
Page 191: ...W 5 ...
