Horizon Hobby JR DSM 12X, Instruction And Programming Manual, Page: 117 / 192

H-31
The Throttle Hold function is designed to hold the throttle
output position in a specific position when the throttle hold
switch is activated but still allow full pitch and cyclic control.
Throttle Hold is normally used for autorotations or can be
used as a throttle safety switch with electric models. The
1. Highlight and select THRO Hold in the FUNC.LIST to obtain
the Throttle Hold Display.
2. Pressing the Selector will activate (ACT) or inhibit (INH) the
Throttle Hold function.
3. Once the Throttle Hold function is activated, the screen will
display the current Throttle Hold value.
16: Throttle Hold
Accessing the Throttle Hold Function
4. Move the Selector to highlight HOLD Pos, then press. Roll
the Selector to increase or decrease the Throttle Hold value
to the desired position.
Note : When the Throttle Hold is activated, and the switch
is on, the ‘’HLD“ indication on the main screen will be
displayed just under the model name.
Stick Auto
The Stick Auto function allows throttle hold to be activated
automatically when the Throttle Hold switch is activated and the
throttle is reduced below the programmed position. Although
To Activate the Stick Auto Function
1. Highlight the Stick Auto function with the selector, and
press to access. Next, roll the selector to increase/decrease
the position of the cutoff point.
Hold Delay
The Hold Delay function allows the throttle servos movement to
be slowed when switching from Throttle Hold back to a previous
Flight Mode. This feature is helpful when practicing Autos.
If the autorotation attempt is aborted, when the Throttle Hold
To Activate the Hold Delay
1. Highlight the Hold Delay function with the selector, and
press to access. Next, roll the selector to the desired delay
position, and press the selector to store. A good starting
value is .75 (3/4) of a second.
Throttle Hold switch is defaulted to the top right-rear corner
of the transmitter, however, a different switch can be selected
in the Device Sel section in the System Mode. In the forward
position, Throttle Hold is on; in the rear position, Throttle
Hold is off.
the Throttle Hold switch is active, when using this feature the
throttle will continue to function until the throttle stick is moved
below the desired cut position selected by you.
switch is released, the throttle will increase slowly, eliminating
the sudden burst of power and preventing damage to the gear
train. The Hold Delay adjustable range is from 1/10 of a second,
up to 2 seconds.