A-42
The 12X features a preprogrammed Elevator-to-Flap mix.
The mixer causes the Flaps (or Flaperons) to move when the
Elevator is moved, resulting in tighter looping maneuvers, or
to provide some Aileron reflex for some 3D maneuvers such as
Harriers. Typically, the flaps are set to travel downward with up
Elevator and to travel upward with down Elevator. The direction
that the flaps travel with Elevator input can be changed by using
positive and negative values.
1. Highlight and select ELE
FLP M in the FUNC.LIST to
obtain the Elevator-to-Flap mix display.
2. There are 2 sets of mixing values available – Pos0 or Pos1.
If the Pos0 values are left at 0% then the mixer may be
turned on and off – Pos0 will be OFF and Pos1 will be ON
(this can be reversed by leaving the Pos1 values at zero
and putting values in Pos0). Highlight and select DN next
to Pos1 and set the value to give the desired amount of
Flap travel in the Down direction when full Up Elevator is
applied.
3. Highlight and select UP next to Pos1 and set the value to
give the desired amount of Flap travel in the UP direction
when full Down Elevator is applied.
4. Scroll down to the bottom line of the display to select the
Flight Mode(s) and/or switch(s) that is to be used to turn
the mixer on and off. The throttle may also be used to turn
the mixer on and off by highlighting and selecting THRO
STK and setting the percentage of throttle to the point where
the mixer is to switch between On and Off.
63: Elevator to Flap
To Program Elevator-to-Flap Mixing
Summary of Contents for JR DSM 12X
Page 191: ...W 5 ...
