A-33
Use Sub Trims to fine-tune the output alignment of the servo
arms.
15: Sub Trim
1. Highlight and select Sub Trim in the FUNC.LIST to obtain
the Sub Trim Display.
To Program Sub Trim Values
The throttle hold function is normally used as a kill switch
for glow-powered airplanes or as a safety/ arming switch
for electric-powered aircraft. It can also be used to preset a
programmed throttle position for electric sailplanes to give full
power when the switch is activated. The throttle hold function
16: Throttle Hold
1. Highlight and select THRO Hold in the FUNC.LIST to obtain
the Throttle Hold Display.
2. Highlight IHN and press the roller to activate the Throttle
Hold function.
To Activate Throttle Hold:
switch position and direction is assigned in Device Select. The
programming of the throttle hold switch position is done in
Device Select screen in the System mode (see page A-21).
Note
: Throttle hold is defaulted to the mix switch.
3. Highlight the HOLD Pos. and press the roller to allow
throttle hold positions to be adjusted. 0% = low throttle low
trim. 100% =full throttle.
Note
: The currently selected Throttle Hold switch is
displayed under ACT. MIX SW is the default setting. To
select another switch see Device Select Throttle Hold on
page A-21.
2. Highlight and select the channels where the sub trims must
be adjusted. Once a channel is selected, rotate the Selector
until the servo arm is in the desired position.
Summary of Contents for JR DSM 12X
Page 191: ...W 5 ...
