96
SRAM (I003)
INTRODUCTION
Sur les châssis futurs, la position I003 sera utilisée pour une SRAM permettant le stockage de page de télétexte et un stockage de
mémoire. Un composant de 128 ko sera probablement installé ici pour permettre l'acquisition et le stockage de 100 pages de
télétexte, et leur accès rapide immédiat. La SRAM est connectée aux lignes d'adresse et de données du microcontrôleur, qui sont
partagées avec l'EPROM/MTP à la position 2.
DESCRIPTION
CONNEXIONS D'ALIMENTATION / MASSE
•
Les broches 32
et
16
sont les connexions d'alimen5V et de masse respectivement. La tension d'alimentation de
+5V est toujours présente, même lorsque le téléviseur est dans le mode veille.
CONNEXIONS DES LIGNES D'ADRESSE
•
Les broches 2
à
12
,
23, 31
et
25
à
28
sont les lignes d'adresse requises pour l'accès aux 128 ko de données par le
microcontrôleur.
CONNEXIONS DES LIGNES DE DONNÉES
•
Les broches 13
à
15
et
17
à
21
sont les 8 lignes de données requises pour recevoir / transmettre un octet à la fois du /
au microcontrôleur.
CONNEXIONS VALIDATION DE CIRCUIT
•
Les broches 22
et
30
sont deux entrées d'activation de circuit qui doivent être BASSE et HAUTE respectivement pour
que le composant 128ko fonctionne. Si la broche 22 est HAUTE ou si la broche 30 est BASSE, le composant entre dans
le mode veille, ce qui permet de réduire énormément sa consommation (10 µV). La broche de sortie MMU3 du
microcontrôleur (broche 2) est utilisée pour sélectionner la SRAM lorsqu'elle est au niveau haut. Si cette broche est au
niveau bas, la MTP/EPROM à la position I002 sera sélectionnée.
CONNEXIONS ACTIVATION D'ÉCRITURE
•
La broche 29
est l'entrée d'activation d'écriture, active basse, utilisée pour permettre le stockage des données dans le
composant. Cette broche est connectée à la ligne lecture/écriture du microcontrôleur à des fins de synchronisation.
INVERSEUR HEX 74CH04 (I004)
INTRODUCTION
Le CI à 14 broches à la position I004 est un inverseur hex CMOS à haute vitesse utilisé pour inverser les signaux numériques.
L'ensemble comprend 6 inverseurs, mais 4 seulement sont utilisés dans cette application.
DESCRIPTION
CONNEXIONS D'ALIMENTATION / MASSE
•
Les broches 14
et
7
sont les connexions d'alimen5V et 0V respectivement. La tension d'alimentation de +5V est
toujours présente, même lorsque le téléviseur est dans le mode veille. Le condensateur C023 est connecté à la borne
d'alimentation pour découplage.
CONNEXION VALIDATION DE CIRCUIT
•
La broche 1
est connectée à la sortie MMU3 du microcontrôleur est utilisée pour sélectionner soit la MTP, soit la SRAM.
Ce signal est inversé et sort de la broche 2 qui est alors connecté à l'entrée de validation de circuit, active basse, (broche
22) de la SRAM. De cette façon, seule une ligne de validation de circuit du microcontrôleur a besoin d'être employée pour
activer la SRAM.
CONNEXION DÉSACTIVATION DTT
•
La broche 3
est l'entrée de désactivation DTT de la broche 7 de I006. Cette entrée est inversée et sort sur la broche 4,
avant d'être connectée aux broches 12 et 13 du commutateur analogique (I008).
CONNEXION DÉSACTIVATION I2C
•
La broche 5
est l'entrée de désactivation I2C de la broche 33 du microcontrôleur. Ce signal est inversé et sort sur la
broche 6, avant d'être connectée aux broches 5 et 6 du commutateur analogique (I007). Lorsque le microcontrôleur est
en condition de remise à zéro, ou lorsque le téléviseur est en mode veille, la ligne de désactivation I2C est HAUTE. Ce
signal doit être inversé pour désactiver le bus I2C du microcontrôleur du bus I2C du reste du châssis.
CONNEXION DÉSACTIVATION SCART
•
La broche 13
est l'entrée de désactivation Scart de la broche 39 du microcontrôleur. Cette entrée est inversée et sort sur
la broche 12, avant d'être connectée aux broches 12 et 13 du commutateur analogique (I007). Lorsque le microcontrôleur
est dans l'état de remise à zéro, ou lorsque le téléviseur n'est PAS dans les modes entretien/diagnostic, les lignes de
transmission/réception RS232 DOIVENT être déconnectée des broches 10 et 12 de la prise Scart 2. Cette ligne doit alors
être inversée pour empêcher toute connexion.
Summary of Contents for C28W40TN
