Hitachi C28W40TN, Service Manual

Page: 309 / 394

external equipment connection - analogue
11
AV1 AV2
RF OUT
SERIAL PORT
LINE
C.1
C.2
R L
S
C
AUDIO LINE OUT
L R
2 X 12W 8
Use this socket to
connect ordinary VHS,
S-VHS or Hi8 equipment
to your TV. It is also used
for digital output.
The 18V power
output socket is specifically
designed for HITACHI
accessories - under no
circumstances connect any
other accessory to this
socket as this could cause
irreparable damage to your
equipment.
Use these connections to attach your leads to the amplifiers and speakers:
S is for the surround amplifier and speakers
C is for the centre amplifier and speaker
R is for the right amplifier and speaker
L is for the left amplifier and speaker
Once connected de-activate 3DS system (see page 28) and set Speaker Setup to WIDE or NORMAL
mode (see page 30) - with this configuration, using 5 external speakers full Dolby Pro Logic can be
achieved enhancing your viewing and listening experience.
R
L
L R
S
C
AUDIO LINE OUT AV1 AV2
2 X 12W 8
Use this to connect digital video
broadcasting equipment, home
computers and home entertainment
systems to your TV. Output from this
connector can be selected. See AV
setup on page 32.
This should be
permanently connected to
an RF source - i.e your
aerial antenna.
The DIN sockets are
used to connect two
external speakers for which
no amplifier is necessary.
R is for the right external
speaker, and L is for the
left external speaker.
...notes on audio equipment
If you have purchased your TV complete with Hitachi’s power console please refer to the Users
Guide supplied with the equipment.
Your HITACHI dealer can also advise you on the correct amplifier and speaker choice for your TV.
18V socket
AV2 scart input
AV1 scart input
RF aerial socket
quad phono sockets
DIN sockets
Before connecting
external equipment,
please consult
AV setup
on page 32.