High End Systems High End LCD Controller for Studio Color, User Manual

Page: 30 / 272

1-8 Setting the Controller Voltage Studio Color LCD Controller
Set or Verify Controller Voltage
To change or verify the controller’s input voltage setting,
locate the voltage selection switch on the rear panels shown in
Figure 1-1 on page 1-9.
115 volts – This setting should be used for power supplies
rated from 90V to 127V. Slide the switch so that “115”
appears inside the switch opening. You must also do both of
the following:
• Change the controller’s fuse as shown in the section titled
“Replacing the Fuse” on page 1-9.
• Verify the controller’s frequency by setting personality
switch B-2 as shown in the section titled “Switch B-2:
Time Base” on page 2-6.
230 volts – This setting should be used for power supplies
rated from 180V to 250V. Slide the switch so that “230”
appears inside the switch opening. You must also do all of
the following:
• See the section titled “Power Cord Cap” on page 1-10.
• Change the controller’s fuse as shown in the section titled
“Replacing the Fuse” on page 1-9.
• Verify the controller’s frequency by setting personality
switch B-2 as shown in the section titled “Switch B-2:
Time Base” on page 2-6.
Caution Do not plug a controller set to 115 volts
into a 230 voltage source. Permanent
damage will occur.