Herz pelletstar 10, Operating Instructions Manual

Page: 65 / 96

Terms and definitions 8
Betriebsanleitung_PS_10_60_Touch_Englisch_V1.3 65
Position Term
Display- /
Setting value
Description
Figure 7.34
Switching temperature Setting value
The switching temperature works as an
average value generator. This means that
from when it is first switched on, an
average temperature generation of the
external temperature begins. This runs
continuously in the background. Should
the daytime average target temperature
be exceeded, this is an indication for the
control that it should be changed to the
automatic summer mode. In general the
switching temperature conduces to switch
between winter must temperature and
summer
must temperature and
backwards.
Temp. increase Setting value
Adjusting the temperature increase for
the required temperature

Due to power loss you can adjust an
addition to the must temperature
winter/summer of the tank circuit
Figure 7.35
Balance tank Setting value
After the boiler is switched off (e.g. for
burner cleaning) there is firstly a
comparison
to check whether the
required temperature (at the buffer) is
available. Should this temperature not be
reached then the boiler no longer starts
up (even if, for example, buffer below
target is not reached)
Fastrun heating Setting value

By pressing this button the fastrun
heating is activated. That means, the
buffer is heated up to the buffer top
must temperature and so the
required
temperature is faster
available for the heating circuits.

The “must temperature top” is the
highest temperature demand of the
connected heating circuits as far as
they are supplied from the buffer.