Herz pelletstar 10, Operating Instructions Manual

Page: 59 / 96

Terms and definitions 8
Betriebsanleitung_PS_10_60_Touch_Englisch_V1.3 59
Position Term
Display- /
Setting value
Description
Figure 7.21
ID fan correction
Display value
Display of the actual induced-draught fan
correction of the lambda control in %
Material correction
Display value
Display of the actual material correction of
the lambda control in %
Insertion
– tact
Display value
Material will be fed in at the adjusted
interval (display in tenth of a second)

Interval is adjusted by the customer
service
Insertion
– pause
Display value
In this interval no material will be fed in
(display in tenth of a second)

Interval is adjusted by the customer
service
O
2
[%]
Display value
Display of the O
2
– values
CO
2
[%]
Display value
Display of the CO
2
– values
Figure 7.22
Residual heat temperature
Setting value
The back flow pump is running after the
burnout of the boiler until the boiler
temperature falls below the adjusted
residual heat temperature.
Control hysteresis
Setting value
The control hysteresis is that temperature
which regulates above the required
temperature. In this range the boiler runs
no longer with full load, but with a
capacity between 30 and 100%.
Minimum requirement
Setting value
Adjusting of the boiler-minimum-set
temperature
Power max
Setting value
Maximum output of the boiler.
Range 30..100 [100] %
Fuel
Setting value
Here you have the option to choose from
the predefined fuels
(e.g.: Pellets, wood chips, and so on)
Figure 7.24
Grate cleaning*
Display- / Setting
value
Indication of the state of the grate
cleaning:

When the indicator lamp lights up the
grate will be cleaned automatically
Stoker screw*
Display- / Setting
value
Indication of the state of the stoker screw:

When the indicator lamp lights up the
fuel will be inserted