Herz pelletstar 10, Operating Instructions Manual

Page: 72 / 96

8 Terms and definitions
72 Betriebsanleitung_PS_10_60_Touch_Englisch_V1.3
Position Term
Display- /
Setting value
Description
Figure 7.50
Hot water tank priority
Setting value
Activation hot water tank priority, i.e. the
hot water tank is loaded prior compared
to the heating circuit.
Kneeling barrier
Setting value
Activation kneeling barrier, i.e. the
heating circuit is locked by durable
kneeling resp. outside the loading time.
Figure 7.52
Flow max. temperature
Setting value
Maximum Flow temperature (however
this value can be exceeded by 5 °C for
the purpose of regulation!!!)
Root point temperature
Setting value
Setting the minimum flow temperature
Flow temperature at +10°C
Setting value
Setting flow temperature at +10°C
outside temperature
Flow at adjustable outside
temperature
Setting value
Setting flow temperature at a adjustable
outside temperature
Adjustable outside
temperature
Setting value
Heating circuit cut-out temperature
setting, i.e. the outside temperature
above which the heating circuit will be
switched off.
Actual outside temperature
Display value
Indication of the actual outside
temperature in °C
Switch off temperature
Setting value
The value of the outside temperature
above which the heating circuit will be
deactivated. This should not be confused
with the daytime average target
temperature since here, only the relevant
heating circuit will be deactivated.
Figure 7.54
Heating circuit pump*
Display- / Setting
value
Indication of the state of the heating
circuit pump:

When the indicator lamp lights up
the heating circuit pump is running
Heating circuit mixer
OPEN*
Display- / Setting
value
Indication of the state of the heating
circuit mixer:

When the indicator lamp lights up
the heating circuit mixer is open
Heating circuit mixer
CLOSE*
Display- / Setting
value
Indication of the state of the heating
circuit mixer:

When the indicator lamp lights up
the heating circuit mixer is closed
8.5 Time mode
Position Term
Display- /
Setting value
Description
Figure 7.56 Time requirement
Setting value
Is intended for the situation where no
heating circuits are connected and the
system is only being used to produce
energy. I.e. within the adjusted time
values, this is the desired boiler must
temperature.