Herz pelletstar 10, Operating Instructions Manual

Page: 67 / 96

Terms and definitions 8
Betriebsanleitung_PS_10_60_Touch_Englisch_V1.3 67
Position Term
Display- /
Setting value
Description
Figure 7.42
Must temperature
Setting value
Adjusting the must temperature of the hot
water tank in °C
Min. loading / temperature
Setting value

Outside the loading time the hot
water tank temperature is loaded to
the adjusted min. temperature. The
condition is the activated min.
loading.

Inside the loading time the loading of
the hot water tank happens when the
hot water tank temperature is under
the value of the adjusted min.
temperature.
Temp. increase
Setting value
Adjusting the temperature increase for
the required temperature

Due to power loss you can adjust an
addition to the must temperature
winter/summer of the tank circuit
Max. loading time
Setting value
Adjusting the maximum hot water tank
loading time in hours, in which the hot
water
tank is loaded on must
temperature.
Legio temperature
Setting value

Setting value for the hot water tank
temperature (Hot water tank is
heated up to this temperature to kill
bacteria)

A deactivation of this parameter is
done by setting the temperature on
0°C.
Circulation pump
Setting value
Activation of the circulation pump

During the hot water tank loading
time the circulation pump is switched
on all 10 minutes.

The circulation pump is switched off
when the circulation temperature is
higher than the min. temperature of
the hot water tank
– 5°C resp. after 5
minutes.
Loading valve
Setting value
Activation of the loading valve