Henny Penny ROTISSERIE SCR-6, Service Manual

Page: 8 / 70

Henny Penny SCR-6/8
2-3. STACKING
INSTRUCTIONS
NOTE
A Stacking Kit must be used to stack rotisseries, or to stack a
rotisserie on a display. This kit ensures 3 inches clearance
from a rear wall. The part numbers of the stacking kits are
02664, for use on the SCR-6 and SCD-6, and 02665 is used
on the SCR-8 and SCD-8.
1. Lay unit on it’s side and bolt locking casters or legs, to
the control side of unit.
2. Using the bolts provided for the non-locking casters, or
legs, bolt both the stacking spacer (provided in the kit)
and the non-locking caster, or legs, to the front side of the
unit. The stacking spacer should extend out the front of
the unit about three inches.
3. Carefully lift the rotisserie and place it on top of the
display, or bottom rotisserie, with the controls on the
same side.
The SCR-8 weighs approximately 500 lbs. (230 Kg) and
the SCR-6 weighs 380 lbs. (172 Kg). Extreme care
should be taken when lifting the rotisserie to prevent
personal injury.
Figure 2-1 4. Remove the three side panel screws from the top unit
and remove the three top side panel side screws from
the bottom unit.
5. Mount the stacking brackets to each side of the units, as
shown in Figure 2-1, using the screws removed in step 4.
6. Unit is now ready for use.
NOTE
For units being installed in Canada, for Price Costco,
proceed with the following steps:
7. Remove the black plug button from the top of the upper
unit.
2-2 698