Henny Penny ROTISSERIE SCR-6, Service Manual

Page: 19 / 70

Henny Penny SCR-6/8
3-12. CLEANING 1. Turn all controls to OFF and disconnect the electrical
PROCEDURES power supplied to the unit.
Allow the unit to cool before cleaning, as the exterior and
interior of the cabinet may be hot enough to cause burns.
2. Remove the discs and rod assembly and take to a sink to
clean them thoroughly. (See Section 3-3).
NOTE
If door of unit is partially open it is designed to close
automatically. To keep door open, position door fully
open.
Be sure to keep groove in the rod clean of debris. The
retaining ring must fit securely in the groove to keep rod
assembly from falling and damaging unit, or causing
personal injury.
3. Pull grease pan partially out and unscrew drain plug to
discard grease into another container.
4. Remove grease pan, vent panels (side vents first), back
panel, and grease trays from unit, and take to a sink to
clean thoroughly.
NOTE
The top vent panel (covering air heaters), is slotted to the
right on the SCR-8 and to the left on the SCR-6.
500 3-9