Henny Penny ROTISSERIE SCR-6, Service Manual

Page: 21 / 70

Henny Penny SCR-6/8
SECTION 4 . PROGRAMMING
4-1. INTRODUCTION The controls can be preset at the factory, or the desired
functions can be programmed in the field. The Program
Settings (“P”) button is used to program the following
functions: Cooking(steps), alarms, and hold.
NOTE
An exception is the Manual mode. Cook time and temperature
can be programmed into this slot without entering the program
mode.
4-2. PROGRAMMING FOR 1. Press and hold the Program Settings (“P”) button until
COOK AND HOLD the control beeps and the display shows “PROG”, then
release the “P” button.
2. Enter the access code 1-2-3 by pressing the button under the
digit. The Alarm button is under the 1, the Down button is
under the 2, the Up button is under the 3.
The control will sound three quick beeps, the word “STEP”
lights up above the “P” button and the settings for the
currently selected product are shown. The product, (P1
through P9), flashes then “COOK-1” shows in the top
display.
NOTE
If the incorrect access code is entered, the Programing
mode is denied. A “BAD CODE” message shows
on the display and a warning tone is generated. After
approximately 10 seconds the control returns to normal
operation and the access code may be tried again.
3. Select the product to be programmed, P1 through P9, using
the Up and Down buttons under PRODUCT SELECTION
NOTE
Once the desired product is selected, each press of the Pro-
gram (“P”) button advances to the next cook or hold step. The
parameters are described below.
4. Once the product is selected the preheat/cook temperature can
be entered. Press the Up and Down buttons under the tempera-
ture display until the desired temperature shows in the dis-
play.
5. The time can be programmed by pressing the Up and Down
buttons under the time (middle) display.
Example: “1:30:00” is 1 hour, 30 minutes, and 0 seconds.
NOTE
Up to four times and temperatures
can be programmed per cook cycle
698 4-1