Henny Penny ROTISSERIE SCR-6, Service Manual, Page: 18 / 70

Henny Penny SCR-6/8
3-7. OPERATION MODE 3 Open the door and load the product into the unit. Press the
(continued) rotate knob as needed to rotate the discs to help in loading.
Close the door, then press the START button to begin cook
cycle.
NOTE
The middle display shows the time remaining and the bottom
display shows the set point temperature. The actual tempera-
ture shows when the Oven Temperature button is pressed.
4. At the end of the cook cycle an alarm will sound, the
middle display shows “0:00” and the top display flashes
“DONE”. Press the STOP button to end the cook cycle.
NOTE
If a hold time is not programmed, the cycle is ended and
alarm turned off by pressing the STOP button. If a hold
time is programmed, the unit will sound an alarm and
automatically go into the hold cycle. Hold time remaining
and temperature will be displayed.
5. At the end of the hold cycle, the middle display flashes
“0:00” and the top display flashes “END”. Pressing the
STOP button stops the alarm and rotor, and all outputs are
off.
NOTE
To abort a Cook or Hold cycle, press and hold the STOP but-
ton for 2 seconds. The cook cycle can also be paused by press-
ing and releasing the STOP button. If power is removed at any
time, the control will resume the operation that was active at
power down, whether it was in a cook cycle, hold cycle, or
preheat.
3-8. PREHEAT CONTROL During preheat, the air heat and radiant heat are both turned
on to regulate the air temperature to the programmed
preheat/cook setpoint. Both air and radiant heat are
turned off when the air temperature is above the setpoint.
The blower runs continuously, but the rotor is off.
3-9. COOKING CONTROL Normally during a cook cycle, the air heating elements and
the radiant elements are regulated to the programmed air
temperature set point.
3-10. DOOR SENSOR If either door is opened during a cook cycle, all functions are
turned off, and remain off until both doors are closed. The top
display shows “DOOR IS OPEN”. But, if the meat probe is
plugged into the unit and the control side door is open, the top
display will show meat probe temperature.
3-11. HOLD CONTROL The hold mode can be programmed for time and temperature.
3-8 698