Henny Penny ROTISSERIE SCR-6, Service Manual

Page: 45 / 70

Henny Penny SCR-6/8
7-11. DOOR SENSOR
REPLACEMENT
(continued)
5. Using a Phillips head screwdriver and a 5/16" wrench, re-
move screws from switch and remove switch from bracket.
6. Cut wires behind splices and then splice wires of new
sensor on existing wires.
7. Install new sensor on bracket, and install bracket assem-
bly onto unit.
8. Replace side panels and restore power to unit.
DO NOT over-tighten the screws securing the sensor to
the bracket, or damage to the sensor will result.
7-12. SOCKET - HALOGEN
LAMP 1. Remove electrical power supplied to unit.
Remove electrical power supplied to the unit by unplug-
ging the unit, or by turning off the wall circuit breaker, or
electrical shock could result.
2. Remove appropriate side panel.
3. Remove Halogen lamp from socket. (See Section 7-1.)
4. Cut wires going to the socket, at the white wires, behind
the splicers.
5. Remove the two Phillips head screws securing the socket
and remove socket from unit.
6. Splice wires of new socket onto existing wires and install
socket and lamp back into unit.
7. Replace side panel and restore power to unit.
698 7-9