28
User Manual Version 3.1
5.3
How to setup the feeder
To setup the feeder you need to perform the following steps in this order:
1. Adjust
the
separation
2.
Adjust the transport roller height
3.
Adjust the paper side guides
4.
Fill the feeder with material
5.
Adjust the paper feed ramp
1. Adjust the
separation
•
Open the fixing screws of both separators and lift them.
•
Depending on you medium put one or two pieces under all four
separation fingers.
Thin medium (e.g. single sheets with 100 g/m²)
= two pieces under the fingers
Envelopes
= put the thickest part of the envelope (= flap) under the fingers
When using a narrow medium put two or more pieces next to each
other so that there is material under each separation finger.
Setup all separation fingers
Make sure that there is a medium under each
separation finger. Otherwise unused fingers could
wear the feed rollers (see Figure 9).
•
Drop the separation fingers so that they sit on the medium.
•
Lock both fixing screws.
•
Pull out the medium.
Figure 8: Adjusting the separation
fixing screw
medium
separation
fingers
separator
