Chapter 7 Administrative Procedures
© 2017 Harmonic Inc. All rights reserved.
215
Harmonic MediaGrid Release 4.1
Powering Down a Harmonic MediaGrid System
13. From the SystemManager platform, click the
Start
button on the taskbar, and then click
Shut
Down
to shut down the SystemManager platform. Disconnect the power cord if necessary.
14. Power down the Network Switches by disconnecting the power cords.
Powering Down or Restarting a Single ContentDirector
1. From the
Configuration
tab, click the
Servers & Switches
icon in the left-hand column to
open the
Servers & Switches
page.
2. In the
ContentDirectors
section, click the name of the ContentDirector you wish to power
down. The
ContentDirector Properties
page appears.
3. Click the
Shutdown
button located at the bottom of the General Properties section.
4. When the confirmation message appears, click
OK
.
5. Check the
Status
field to verify that it indicates
Not Responding
. Note that this may take a few
minutes depending on the length of the discovery cycle and the status of other devices in
your network.
6. Disconnect the power supply.
To restart a single ContentDirector without removing the power supply:
1. From the ContentDirector Properties page, click the
Reboot
button located at the bottom of
the General Properties section.
2. When the confirmation message appears, click
OK
. The ContentDirector will restart.
3. Check the
Status
field to verify that it changes to
Not Responding
, and then returns to its
previous state. Note that it may take a few minutes for the status to change, depending on the
length of the discovery cycle and the status of other devices in your network.
Powering Down or Restarting a Single ContentBridge
To power down a single ContentBridge:
1. From the
Configuration
tab, click the
Servers & Switches
icon in the left-hand column to
open the
Servers & Switches
page.
2. In the
ContentBridge
section, click the name of the ContentBridge you wish to power down.
The
ContentBridge Properties
page appears.
3. Click the
Shutdown
button located at the bottom of the General Properties section.
4. When the confirmation message appears, click
OK
.
5. Check the
Status
field to verify that it indicates
Not Responding
. Note that it may take a few
minutes for the status to change, depending on the length of the discovery cycle and the
status of other devices in your network.
6. Disconnect the power supply.
To restart a single ContentBridge without removing the power supply:
1. From the ContentBridge Properties page, click the
Reboot
button located at the bottom of the
General Properties section.
2. When the confirmation message appears, click
OK
. The ContentBridge will restart.
3. Check the
Status
field to verify that it changes to
Not Responding
, and then returns to its
previous state. Note that it may take a few minutes for the status to change, depending on the
length of the discovery cycle and the status of other devices in your network.
