HappyJapan HCS2, Instruction Book

Page: 240 / 354

-SA -106
23-4
SPECIFICATIONS ･ MAINTENANCE
10_2 T422
1. Remove set screw (2 pieces) by offset driv-
er and remove the needle plate.
2. Turn the main shaft toward the arrow mark
until the gauge points to the “C” point by
using the 3 mm hexagonal driver.
3. Insert manual lever and pull down the man-
ual lever that is in the left hand side of the
machine as you face it.
4. Keep pressing the manual lever and turn
the main shaft toward the arrow mark until it
points to the “L” point.
5. Remove any waste thread and dust from the
thread cutting knife and surrounding area.
6. Adjust the main shaft until the gauge points
to the “C” point.
Thread cutting knife returns to the original posi-
tion.
7. Remove manual lever and put the needle
plate back on the bed and attach it with the
screws (2 pieces).
Please do not keep manual lever to knob.
Please take care of manual lever.
CAUTION: To prevent accidents.
When taking care of the machine, be sure to remove the plug.
C
1 2
4
CAUTION: To avoid problems.
Never press the manual lever while
the machine is running.
L
3
Cleaning the thread cutting knife (Before Rev. A)
If the thread cutting knife is clogged with waste thread or dust, the knife will not work correctly.
Please keep the thread cutting knife and device
clean.