Hand Held Products SCANTEAM 2070, System Manual

Page: 72 / 232

3 - 10
Host Port Communications
Decode Beep Selection
Note: Decode Beep mode is active only when the programming selections Host
ACK (page 3-6) or Data Format Required (page 5-26) are turned on.
When Host ACK Selection is on, the scanner will only beep/blink in response to
the Escape commands generated by the host. Should you also want the scanner
to beep when a bar code has been successfully decoded and successfully
communicated to the base, turn the Decode Beep Selection on.
When Data Format Required is on, the scanner will only beep if the input data
conforms to the edited format or triple beep if it does not meet the format
requirements. Should you also want the scanner to beep when a bar code has
been successfully read and sent to the host from the base, turn on the Decode
Beep Selection.
On
*Off