Hand Held Products SCANTEAM 2070, System Manual

Page: 25 / 232

1 - 5
Proper Disposal of the Charge Pack
When the charge pack has reached the end of its useful life,
the charge packs should be disposed of by a qualified recycler
or hazardous materials handler. Do not incinerate the charge
pack or dispose of the charge pack with general waste
materials. Contact the Product Service Department (see page
11-1) for recycling or disposal information.
Charging Your Charge Pack
(CLESS/NIMH/S)
Charge the charge pack by following the steps below:
1. Detach the charge pack from the bottom of the scanner. (See figure below)
2. Fully charge the charge pack. Plug the
charge pack directly into any common
120 V AC outlet in North America. If
outside North America, use the custom
charge strip or adaptor.
3. The LED on the bottom of the charge
pack blinks red temporarily as part of
the charge initialization sequence.
After initialization, the LED remains
solid red while the charge pack is
charging. The LED shows green when
the charge pack is fully charged and
ready to use.
Recharge Time: 6 hours at any voltage at
20
°
C (68
°
F).
4. After the charge pack is fully charged, attach it to the cordless scanner by
pressing the pack firmly (align the prongs on the pack with the mating recep-
tacles) in the base of the scanner until the release buttons click, holding the
pack firmly in place. (
When you attach a charged charge pack to the cord-
less scanner, you will hear a single beep.)
5. If you have not set up your Cordless System, turn to “Setting Up and Con-
necting the Cordless System” on page 1-8 for instructions.
6. If the scanner wasn’t previously associated to the base, scan the association
bar code on the top of the base. If the scanner was previously associated to
a base, it will automatically re-associate. (The association process takes
about ten seconds.)
Press Release Buttons
(2 Places)