Hand Held Products SCANTEAM 2070, System Manual

Page: 30 / 232

1 - 10
4. Using the cordless scanner, scan the Association Bar Code (the bar code
label on the top of the base) to link that scanner to the base.
Two quick beeps followed by clicking, then a single beep indicates a “good”
association. The scanner is in communication with the base. If the scanner
clicks for 30 seconds and signals an error (triple beep), it has not associated with
the base.
Note: If the charge pack is removed from the scanner and replaced after
association, the scanner automatically reassociates to the base, if the
base has power. In this case, the scanner beeps when a charged charge
pack is installed, then beeps a second time after full association, typically
five to ten seconds later.
Note: A scanner always defaults to work group 0 after scanning a base I.D. bar
code.
5. After your cordless scanner has been associated with its base unit, program
the system to work with your terminal or computer by scanning the Terminal
Setup Codes. Use the Supported Terminal list (page 2-6) to scan your termi-
nal’s Terminal ID.
With Plug and Play programming, you scan only one bar code to program the
cordless system to work with a designated interface, including any required
prefixes and suffixes.
6. To determine if your cordless system is set up correctly, scan one of the
sample bar codes in the back of this manual.
Linear Imager or
Laser Scanner
Cordless Base
Association Bar Code