Hand Held Products SCANTEAM 2070, System Manual

Page: 115 / 232

5 - 13
Laser Marker Beam (ST5770 only)
When this selection is turned on (short or long duration), the cordless scanner
shows a marker or locator beam before the red scan line opens across a bar
code and the scanning process begins. The marker beam, emitted by centering
the optical scan mirror, appears as a bright spot of illumination that serves as an
aiming guide when bar code targets are at a distance from the scanner.
Note: If this selection is turned on, scanning is delayed for 0.5 or 1.2 seconds
while the marker beam is enabled.
AIM Symbology ID and Modifier Prefix
This selection turns the transmission of the AIM Symbology ID on or off before
the decoded symbology. (See the Symbology Chart below for the single AIM
character code that identifies each symbology.) When you scan the
On code, all
current prefixes are cleared, then an AIM I.D. for all symbologies is programmed.
Alternately you may combine an AIM Symbology ID with other characters in a
prefix or suffix. Refer to page 5-16.
*Off
Short Duration (.5 seconds)
Long Duration (1.2 seconds)
On
*Off