Hand Held Products SCANTEAM 2070, System Manual

Page: 36 / 232

1 - 16
System Conditions
The components of the cordless system interact in specific ways as you
associate one or more scanners to a base, as you move a scanner out of range,
bring a scanner back in range, replace a scanner charge pack, or swap scanners
between two cordless systems. The following information explains the cordless
system operating conditions.
Association Process
After you scan the association label, the base synchronizes radio parameters
and the work group parameter table in the scanner. The work group table is
uploaded during the clicking sequence. Two beeps, clicking, then a single beep
indicates the process is complete. The base blinks while it is sending the table
to the scanner. Until the table is uploaded, scanning and data transmission is
interrupted. If the base is off or not working properly, the scanner emits an error
(triple) beep after trying for 30 seconds to associate to the base.
The work group table is also uploaded any time the base believes a previously
associated scanner wishes to join the network. A scanner always tries to join the
last base it was associated to, even if the scanner has been without power for
several days. The base allows a scanner to associate as long as there are fewer
than nine scanners associated to the base.
Note: A scanner always defaults to work group 0 after scanning a base I.D. bar
code.
Scanner Assembly
Decode/Control Assembly
Control
Trig/Decode
RF Port
Menu I/O
Power Mgmt
Cordless Scanner
Engine
Assembly
Beeper
Antenna
Engine Hsg
Window/Lt Pipe
Trigger
Handle
Housing
(Handle Board)
HHLC I/O
Beeper Port
RF
Module
Download Port
Charge Port
Engine Port
Scan Engine
(Linear Imag-
er or Laser
Charge Pack