Hand Held Products SCANTEAM 2070, System Manual

Page: 107 / 232

5 - 5
Programming Keypad Macro Strings (IT3875 and
ST2070-5 only)
Up to eleven keypad macro strings may be set up to save a sequence of keypad
strokes, which later can be recalled by pressing and releasing the FUNCTION
(FN) key and then a digit key (0-9) or by pressing the asterisk (the wildcard key).
Keypad macro strings can be used in combination with individual keyed
characters when entering data using the keypad.
Note: The scanner must be associated to a base (ST2070-5) to use a keypad
macro.
Program the keypad macros by scanning the appropriate bar code on the next
page and then scanning the appropriate hex pair for each character of the macro
(refer to the "IT3875 Font Characters Chart" on page 5-7) and the SAVE bar
codes on the Programming Chart inside the back cover.
Note: If you make an error while scanning the characters (before scanning
Save ), scan Discard on the back cover, scan the correct characters, and
Save again.
Example: If you want to create a macro of the word PRODUCT and assign it
to the (*) key, follow the sequence below.
You may assign up to 20 characters to each keypad macro. Upon pressing a
macro key, each character of the keypad macro string will be shown in the
display, as if each character was keyed in by itself. The keypad macro string will
not be automatically sent to the base. You may press the
ENTER key to accept
the keypad data.
The keypad macro strings are not limited to characters on the keypad. You may
use any of the 256 characters shown in the "IT3875 Font Characters Chart" on
page 5-7. The default settings for these keypad macro strings are null. The
macro key default for the wildcard is the “
* ” character. The scanner ignores
macro keys when the script application is not expecting a key entry.
To clear any macro, scan the bar code for the key to which the keypad macro is
assigned, and scan the
SAVE bar code.
Bar Code
P R O D U C T Scan: ASTERISK Macro
Bar Code
5,0, 5,2, 4,F, 4,4, 5,5, 4,3, 5,4
SAVE