Hand Held Products SCANTEAM 2070, System Manual

Page: 28 / 232

1 - 8
Setting Up and Connecting the Cordless System
Install the base and cordless scanner by following the steps shown below:
Important: Make sure the cordless scanner’s charge pack has been fully
charged. See “Charging Your Charge Pack” on page 1-5 for charging
instructions.
Keyboard Wedge Interface
1. Turn off the power to the host system.
2. Connect the interface cable to the base and to the terminal/computer (steps
1-3, shown in the illustration below). Depending on your application, the
interface cable you need may be different than the one shown.
Note: For optimal coverage, place the base and its antenna as far away from
other sources of RF interference, with a clear transmitting path to the
scanner(s).
The base can be mounted on a wall or a ceiling. Try to place the base so
that the antenna is in a vertical (straight up and down) position whenever
possible. An extra Base Association Bar Code is provided in case the
base is mounted where the label might be difficult to scan (the Association
process is described on page 1-10).
Terminal
(Host system)
Cordless
Base
Disconnect
3
2
1
(Cable, keyboard, and terminal may vary.)
Keyboard Wedge
Interface Example