Hagie 204, Operator'S Manual

Page: 61 / 141

x
V. OPERATING INFORMATION
TASSELTROL
®
TOP PARAMETER
The top parameter is used to adjust the sensi-
tivity of the top photocell. The top photocell starts
the up motion when its lights path is blocked by
corn. How much corn it has to see before starting
the up move can be changed by selecting one of
the four values T1, T2, T3, or T4. With T1 selected,
more corn is required to start an up move. The nor-
mal or default value for this parameter is T3, but
can be set to any desired value.
If the pullers move up too easily when a taller
stalk of corn passes, increase the parameter to-
ward T4. If the pullers stay deep too long when tall-
er corn passes, decrease the parameter toward T1.
Generally this parameter can be left at T3.
To display the top parameter, select “AUTO”
and turn the control box power on. Wait three sec-
onds for the “SELECT MANUAL” message. Press
the “UP” button under “PAR”. Now press the “UP”
button under the “T” value.
1. The active value of the parameter is indicated
by it blinking on and off, while the other three
choices are displayed continuously.
2. To select a new value for the parameter, press
the “UP” button under the desired choice.
3. After selecting one of the four choices, press
any of the “DOWN” buttons to escape this pa-
rameter.
4. To save new values and escape the parameter
mode, press “DOWN” a second time and
switch “AUTO/MANUAL” toggle to “MANUAL.”
TOP PARAMETER
SET TO T1
TOP PARAMETER
TOP
BOTTOM
PHOTOCELLS
FIG 5.37
PRESS UP TO SELECT
T1 T2 T3 T4
NOTE:
See page XX for more information re-
garding the LS photolights.